To get started for setting up your NCTech iris360, please download the JobWalk app to your mobile Android or iOS device and log in. You can learn more about how to work with the JobWalk app in the dedicated article.

Connecting from within the JobWalk app (recommended process)

Start the JobWalk App and download/update an existing project or create a new project. Add a new floor plan/sheet or select an existing sheet of the project. Tab on the sheet to place the first image. Follow the instructions below or on the app screen for setting up the corresponding camera connection for your NCTech iris360.

Connecting before starting the JobWalk app

Alternatively, it is also possible to first establish the connection of your mobile device with the camera and open the JobWalk app in a second step. This way you can directly start capturing on your project.  Simply follow the steps below for connecting to the NCTech iris360.
​When editing an existing project, please make sure to have your HoloBuilder project downloaded/updated before connecting to the camera.

Only when the camera is connected via the internal Wi-Fi Network of the NCTech iris360 camera, you can use your smartphone with the JobWalk App to capture images on-site and place them directly on a sheet.

Make sure the camera and phone are fully charged before going on-site to avoid any bad surprises during the job walk creation process. 

1. Before you start, please make sure a micro SD card is inserted into the camera. The card slot is located on the side of the NCTech iris360 behind a lid.

Note: The JobWalk App will save the images in the app/to the cloud but the original file will always be saved to the camera. In order to have the camera work without any dispruptions, please provide enough storage on the device before capturing new progress on-site.

2. Turn the camera on by toggling the power switch on the side of the iris360 to the 'On' position (left). 

3. On your phone, open the Settings app and switch to the Wi-Fi settings. 

4. Connect your phone to the NCTech iris360's Wi-Fi network (which will end in ".OSC"). The default password is "iris-360".

5. Open the JobWalk app and start capturing.

Note: When the phone is connected to the camera, you’ll see a first instructional screen of how to start capturing with theJobWalk app. 

Note: The NCTech iris360 turns purple when your photo is being created. It’s ok to move the camera while it’s purple. During the capturing the status indicator light is turned off and when the camera is ready again for capturing the light is a solid blue.

For more information on the JobWalk App and additional compatible cameras, please refer to the following tutorials: