To get started for setting up your LG 360 CAM, please download the JobWalk app to your mobile Android or iOS device and log in. You can learn more about how to work with the JobWalk app in the dedicated article.

Connecting from within the JobWalk app (recommended process)

Start the JobWalk App and download/update an existing project or create a new project. Add a new floor plan/sheet or select an existing sheet of the project. Tab on the sheet to place the first image. Follow the instructions below or on the app screen for setting up the corresponding camera connection for your LG 360 CAM.

Connecting before starting the JobWalk app

Alternatively, it is also possible to first establish the connection of your mobile device with the camera and open the JobWalk app in a second step. This way you can directly start capturing on your project.  Simply follow the steps below for connecting to the LG 360 CAM.
When editing an existing project, please make sure to have your HoloBuilder project downloaded/updated before connecting to the camera.

Set up and connect your LG 360 CAM 360° camera with the JobWalk app

Only when the camera is connected via the internal Wi-Fi Network of the LG 360 CAM camera, you can use your smartphone with the JobWalk app to capture images on-site and place them directly on a sheet.

LG 360 CAM setup

Make sure the camera and phone are fully charged before going on-site to avoid any bad surprises during the job walk creation process. When the battery level on the LG 360 CAM camera is low, you will see a red light below the power button (red means 5-15% of battery remaining; red blinking means less than 5% remaining). HInt: For an additional power supply for the LG 360 CAM during the capturing, connect the camera to a power bank via the USB terminal at the bottom of the camera.

1. Turn on the camera by pressing the power button on the side.

2. Turn on the Wi-Fi of the camera by double-clicking the power button and the shutter button at the front of the LG 360 CAM at the same time. When the Wi-Fi is connected, a blue light will flash.

3. On your phone, open the Settings app and go to the Wi-Fi settings.

4. Connect your phone to the LG 360 CAM's Wi-Fi network. 

To find the network more easily, check for a network ending in ".OSC". The default password consists of "00" followed by the last 6 characters of the Wi-Fi network. For example, for Wi-Fi network LGR105_02CNDF the password is "0002CNDF". 

5. Open the JobWalk app.

Note: When the phone is connected to the camera, you’ll see a first instructional screen of how to start capturing with the JobWalk app. 

For more information on JobWalk App and compatible cameras, please refer to the following tutorials:

Did this answer your question?