Skip to main content

Edit the Registration of Blink Scans

Learn how you can edit the registration of Blink Scans for a perfect result.

Stefanie Zerulla avatar
Written by Stefanie Zerulla
Updated this week

Click the Edit registration button.

The Registration - Edit page is displayed. On this page you can manually move scans to the position you want.

This view has the same toolbars as the Registration - Inspect page, see Inspect the Registration of Blink Scans. An additional toolbar on the right side allows adding or removing connections between scans.

You can only edit the registration in the 2D view.

Move and Rotate Scan

1. Select the scan you want to move or rotate in the tree view or in the .

An anchor point is displayed.

1. To translate and rotate one or more scans:

2. Select the scan you want to move or rotate in the tree view or in the . If you want to select more than one scan press and hold the CTRL key, then select the scans.

3. Then drag or rotate the scan until it is in the correct position.

Add or Delete Connections

To add a connection, click the icon and then the two scans you want to connect.

New connections are displayed in gray. Registered connections are displayed green, yellow or red depending on their registration result.

To delete a connection, click the icon and then the connection you want to delete.

Delete Scans

If you cannot register a scan in editing mode, you can delete it by clicking the icon.

Publish Scans

When all scans are positioned correctly:

Click the Refine button.

The scans will be registered at their new positions and published automatically if the registration is successful.

If you are not able to position all scans correctly or if the Refine procedure fails, you can publish the scans as they are without registration.

For this purpose, click the Publish without refinement button.

For more detailed information, see our Sphere XG User Manual.

Did this answer your question?