Skip to main content
How to take measurements in a Point Cloud in the Legacy Sphere Viewer

Directly take measurements within an uploaded point cloud in the Legacy Sphere Viewer with high accuracy.

G
Written by Giancarlo Jimenez
Updated over a week ago

Taking measurements with Point Cloud in Legacy Sphere Viewer

IMPORTANT

The FARO Legacy Sphere Viewer is now Sphere XG - an even more immersive cloud solution to cover all your needs. Talk to us to learn more and transition over! You can always reach us via email at support@holobuilder.com, use the live chat feature in the bottom right corner on HoloBuilder or simply contact your go-to FARO representative.

Note:

You can always reach us via email at support@holobuilder.com, use the live chat feature in the bottom right corner on the HoloBuilder platform or simply contact your go-to FARO representative.


Take Measurements in a Point Cloud

Sphere Viewer UI

  1. Go to the Sphere Viewer. You can take measurements either in walk mode or in the 3D view.

  2. Choose the Walk icon or the 3D icon in the lower left corner of the screen.


    Note:

    Icons that you can click are dark gray, clicked icons are blue, icons that you cannot click are light gray.

  3. Click Point Cloud at the top right corner of the screen. The Point Cloud view opens.

  4. Click the Ruler icon on the right side of the screen.

    Ruler icon

  5. Choose at least two points in the Point Cloud.

The measured distance will be displayed in the measurement unit that was selected during project creation. You can also change the unit, see below.

Note:

If you measure a diagonal distance, the measurements on all three main axes (XYZ) will also be displayed (if larger than 0).


Take Measurements Between Objects That Are Far Apart

If the objects that you want to measure are too far apart and are not visible in the current view:

  1. Left click to select the first measurement point.

  2. Press the Shift key and rotate your view until the next measurement is visible.

  3. Click to select the next measurement point.


Change the Measurement Unit

Available measurement units are ft and m.

By default the measurement unit is taken from the initial project settings.

You can change the measurement unit while making measurements.

  1. When you click on the labels that show the distance, a small toolbar is displayed.

  2. Click the currently displayed unit to change it.

Small toolbar displaying unit


Abort a Measurement

To abort a measurement press the right mouse key.


Delete a Measurement

When you click the second measurement point, a small toolbar is displayed.

Click on the icon to delete the current measurement.


Note:

You can always reach us via email at support@holobuilder.com, use the live chat feature in the bottom right corner on the HoloBuilder platform or simply contact your go-to FARO representative.

Did this answer your question?